KNX news
29 DE AGOSTO DE 2017
NEW DESIGN – TEMPERATURE, HUMIDITY AND CO2 SENSORS WITH TERMOSTAT
Elsner launches a new design, specifically the range of KNX TH-UP Touch controllers, replacing the KNX TH-UP. We are talking about room controllers used for temperature control but can also be used for ventilation control.
Integrated sensors in the KNX TH-UP Touch measure temperature and humidity. In addition there are models with CO2 measurement for air quality, with 2 touch buttons to control the temperature of the room as well as the mode, or with display to show the measured values or information like time. Available in black and white colours.
NEW AVAILABLE CONTROLLERS:
- 70615 y 70616 Temperature and humidity indoor sensors, WITH display and touch buttons (replacement for a 70370, 70374-75)
70618 y 70619 CO2, temperature and humidity indoor sensors, WITH display and touch buttons (replacement for 70239-70242)
70621 y 70622 Temperature and humidity indoor sensors, WITHOUT display or touch buttons (replacement for 70362-70365)
70624 y 70625 CO2, temperature and humidity indoor sensors, WITHOUT display or touch buttons (replacement for 70234-70237)
For further information, please do not hesitate to contact us via telephone +34.965.95.95.11, e-mail commercial@futurasmus-knxgroup.com or check the ONLINE CATALOGUE.
12 DE ENERO DE 2012
All in one from Elsner: Temperature + Humidity + CO2 + display + buttons
- Temperature
- Absolute and relative humidity
- CO2
It also allows PI regulation of temperature (cooling, heating, additional heating and cooling ) PI regulation of CO2 (2 levels), dew point calculation, 4 temperature thresholds, 2 humidity thresholds, 4 CO2 thresholds, register of máximum and mÃnimum value, 8 AND logic functions with 4 inputs each, 8 OR logic functions with 4 inputs each, temperature / humidity and CO2 sensor failure detection and more interesting functionalities.
The display can show up to three lines, in each of which you can visualize the values measured by the sensor, as well as external values of 1 byte or 2 bytes, date, hour or chains of 14 bytes.
The two buttons integrated in the right and left lower corner allow to modify the desired temperature value of the integrated PI regulator, or to be used as KNX pushbuttons for switching, blind control, dimmer control, sending of 1 byte and 2 byte values or to call KNX scenes.
The BCU is integrated in the device as in all the products from this range.
The price is also very surprising, considering the great power and nice aesthetics of this component.
For more information, you can contact us via telephone or email, or take a look at the product’s information found in our website.